![](/images/backgrounds/133274/bgd.png)
Programming
9
AXB-TM5 Television Manager
ProgrammingYou can program the AXB-TM5 to perform a wide variety of operations using Axcess
Send_Commands. This section describes channel settings, IR functions, and system
Send_Commands. Refer to the AXCESS Programming Guide for additional programming
information.
Channel Setting Commands
The AXB-TM5 use the channel setting commands listed in the following table.
Device Assignment
The device assignment must be the same as the device number set on the Device DIP switches
(FIG. 2 on page 3).
AXB-TM5 Channel Settings
Channel Function
1 Generates IR/Serial functions 1, else Off
2 - 127 Channels the generate IR code for the corresponding functions
128 - 247 Push and release channels for received IR code
248 A push on this channel indicates a power failure error
249 Response LED blinks when channels 249 and 250 are On
250 Response LED lights when channel is On
251 I/O is On (switch to GND) when channel is On
252 I/O 2 is On (switch to GND) when channel is On
253 I/O 3 is On (switch to GND) when channel is On
254 I/O 4 is On (switch to GND) when channel is On
255 Channel is On if the TV Power Sensor detects a horizontal scan frequency
Turning a channel (IR/Serial function) on while another one is currently on will
automatically turn the current one off first. Contact closure inputs on I/O 1 through I/O
4 will also generate PUSHes and RELEASEs on channels 251 through 254,
respectively.