AMX manual Installing an MVP-BP Battery into an MVP-TDS

MVP-TDS Table Top Docking Station

Installing an MVP-BP Battery into an MVP-TDS

The MVP-TDS connects directly to a PSN4.4 power supply and provides both power and communication to docked MVP panel. The MVP-TDS can charge batteries in its own battery compartments, as well as those within the MVP panel.

1.Raise the rear connector cover to expose the battery compartments and connectors.

2.Slide the MVP-BP into the battery compartment (AMX label up) until the connector makes contact with the battery pins at the end of the battery slot.

3.Repeat these steps for any additional MVP-BP batteries.

4.The status of the connected batteries are reflected on the panel’s Batteries page and the LEDs on the docking station.

A completely discharged battery requires one full charge cycle from within battery compartment #1. Refer to FIG. 2 on page 2 for locations.

MVP-TDS Table Docking Station for MVP Panels 7