Setting the Device DIP switch | AMX PC Presenter specs

Pre-Installation

1	8	15
2	9	16
3	10	17

2425

27

3029

28

26

4	11	18
5	12	19
6	13	20
7	14	21
22		23

FIG. 9 TXC-MS(L) pushbutton configuration

Setting the Device DIP switch

The eight-position Device DIP switch located on the front panel of the AXR-MSE as shown in FIG. 10 sets the AXlink device number for the AXR-MSE. Each device on the AXlink bus must have a unique AXlink device number.

AXlink	DEVICE	MOUSE	KEYBOARD	DATA

ON

Device DIP switch

FIG. 10 AXR-MSE device DIP switch

If you later change the device number, remove and reconnect the AXlink connector. This enters the new device number into memory.

PC Presenter	9

Image 13

AMX PC Presenter instruction manual Setting the Device DIP switch, TXC-MSL pushbutton configuration

Contents

PC Presenter AMX Limited Warranty and Disclaimer Table of Contents Programming Transmitter Pushbuttons PC Presenter transmitter and receiver units Introduction TXC-MSL Transmitter TXC-MSL Specifications TXC-MSL controls Trigger switchTXC-MSL mouse controls AXR-MSE Specifications AXR-MSE Wireless Mouse and Keyboard ControllerFront Panel Keyboard IN/OUT Rear Panel Introduction Setting the TXC-MSL transmitter DIP switch Pre-InstallationIR and RF Settings Setting radio codes Radio Code SettingsRadio codes DIP switch positions Channel code ranges From TXC-MSL pushbutton configuration Setting the Device DIP switch Device DIP switch positions and values Using the PC Presenter Without a PC ComputerPosition SW3 SW2 Wiring Requirements Setting Mouse Mode Wiring Guidelines Wiring guidelinesPreparing captive wires Wire size Pre-Installation Installing the PC Presenter for Stand Alone Operation Installing the PC PresenterConnecting the AXR-MSE to the PC keyboard and PC Connecting the AXR-MSE to the PC mouse and PC Using AXlink for data and power Installing the PC Presenter for AXlink OperationAXlink data and 12 VDC power supply connections LED indicators Installing the PC Presenter Using PC Presenter Commands Programming the PC Presenter in Stand Alone ModeProgramming the PC Presenter Clear memory List commands HelpShort form listing of keycodes Display available memory Programming Transmitter PushbuttonsLong form list of stored keycodes Display version and copyright info Exiting program mode SendCommands SendCommandsCreating a buffer for keyboard input SendStrings SendStringsRMACROn-s TXIDn Mouse Control Channels Mouse Control ChannelsChannel Direction Speed Using Levels OLDesign main window with example TXC-MS overlay Using the OLDesign Engraving Program Using the OLDesign Engraving Program Replacing the batteries TXC-MSL Battery Replacement AMX reserves