Pre-Installation

The device can be 1 of the 255 devices in an Axcess, Axcent, Axcent2, Axcent3, AXB-MPE, or AXB-EM232 system. The device number must match the device assignment in the Axcess program. AMX assigns device numbers into the following three segments:

Cards - 1 through 95

Boxes - 96 through 127

Panels - 128 through 255

The device number takes effect only on power-up.

Set the device number by setting the device DIP switch. The device number is the total of all of the switches in the ON (down) position. The following table shows the switch numbers and their corresponding values.

Device DIP switch positions and values

Position

Value

11

22

34

48

516

632

764

8128

As an example, the following DIP switch settings define the AXR-MSE as device number 97 (1 + 32 + 64 = 97).

The AXR-MSE can operate without a keyboard. When the unit powers up it checks to see if there is a keyboard attached. If there is not, the unit resets (approx. 5 sec. later) and boots into a mode where it never checks the external keyboard again. You have to cycle power in order for the keyboard to be recognized.

Using the PC Presenter Without a PC Computer

You may want to use the AXR-MSE without a PC computer in certain applications. To use the AXR-MSE and a keyboard without the PC attached, you must set the AXR-MSE's internal slide switches. The internal switches are located on the circuit card inside the MSE enclosure, as shown in FIG. 11.

 

10

PC Presenter

 

 

 

Page 14
Image 14
AMX instruction manual Using the PC Presenter Without a PC Computer, Device DIP switch positions and values, Position