Step 3
Step 4
Step 5
Attach subreflector ring to corresponding strut assembly plates as shown in Figure 60. Ensure subreflector ring assembly is installed with indicated adjustment stud hole at 3 o’clock position as shown. Do not tighten mounting hardware.
•Use 1/2 x
Figure 60
Fully tighten quadrapod plates to reflector segments, struts to quadrapod plates, struts to apex bracket, subreflector ring to strut assembly plates.
Screw 3/4 x 9 in (229 mm) adjustment studs into mounting holes on subreflector as shown in Figure 61. Install 3/4 in flatwashers, nuts and jam nut onto stud.
Figure 61
47 | Installation Procedures |
