Andrew ES73 manual Step Step, Installation Procedures

Step 3

Step 4

Raise 201313A beam assembly to upright position and attach 201315 supports to 201327A joint assembly as shown in Figure 7.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolts from 201327A joint assembly to supports

•Supports should be installed back-to-back with the flat of angle facing upwards

•Tighten supports until assembly can support itself

201315

Supports

Figure 7

Attach 201301/201302 rear pad assembly to 201315 supports as shown in Figures 8 thru 10.

•Use 7/8 x 2-1/4 in (57 mm) bolts and nuts

•Insert bolt from inside of rear pad assembly to outside of support

•Supports should be installed back-to-back with the edges forward and the flats of angles facing rear

Figure 8

14 Installation Procedures