FRYER TROUBLESHOOTING GUIDE (Continued)
| PROBLEM | CAUSE | REMEDY |
|
|
|
|
| Basket does not raise, | 1. Lifting mechanism or motor has failed. | 1. (Continued) |
| after the timer control | (Continued) | If the motor operates, but the |
| knob reaches a timer |
| motor shaft is not turning, the |
| value of 0 (zero). |
| gear inside the lift motor has |
|
|
| failed and the lift motor must be |
|
|
| replaced. |
|
|
| If the motor does not operate, |
|
|
| check for |
|
|
| between the motor’s terminals. |
|
|
| If |
|
|
| between the motor terminals, |
|
|
| yet the motor does not operate, |
|
|
| the motor has failed and must |
|
|
| be replaced. |
|
|
| If no |
|
|
| between the motor terminals, |
|
|
| the microswitch or timer has |
|
|
| failed and must be replaced. |
|
|
| Refer to the following |
|
|
| “Causes” 2 and 3. |
|
| 2. Microswitch has failed. | 2. Check for |
|
|
| measuring between the “C” |
|
|
| terminal (white wire) and the |
|
|
| “NO” terminal (left motor: |
|
|
| black wire; right motor: brown |
|
|
| wire) of the microswitch. If |
|
|
| |
|
|
| between these respective ter- |
|
|
| minals but the motor does not |
|
|
| operate, the microswitch has |
|
|
| failed and must be replaced. |
|
| 3. Timer has failed. | 3. If no |
|
|
| between the microswitch ter- |
|
|
| minals “C” and “NO”, the |
|
|
| timer has failed and must be |
|
|
| replaced. |
|
|
|
|
| Basket lowers and | 1. Lifting mechanism microswitch is improp- | 1. Position the microswitch |
| raises, repeatedly. | erly positioned. | properly. |
|
|
|
|
| Basket raises, after the | 1. Lift motor has failed. | 1. Replace the lift motor. |
| timer control knob |
|
|
| reaches a timer value |
|
|
| of 0 (zero), but then |
|
|
| sinks back into the |
|
|
| kettle. |
|
|
|
|
|
25