Anetsberger Brothers MX-14-2E, MX-7E, MX-14E, MX-14AA, MX-7A warranty Caster Leveling INSTRUC- Tions

INSTALLATION INSTRUCTIONS (Continued)

CASTER LEVELING INSTRUC- TIONS

1.Move the fryer to its desired location.

2.Determine whether the fryer tends to wobble or rock when in its desired location. If it does, perform steps 3 through 9. If it does not, skip to step 10, then proceed to the

Installation Instructions.

! WARNING

The fryer MUST NOT tip, rock or wob- ble, to avoid splashing or spilling its HOT shortening contents during operation.

3. Determine which caster requires adjustment and the approximate amount of change required to level the fryer.

4. Position the side of the fryer on the ship- ping carton, exposing the bottom of the fryer with the caster mounting plates (Figure 4).

5. Completely unscrew the bolts holding the caster mounting plate that requires the leveling adjustment. Retain the locking nuts for later reassembly.

Figure 4. Typical Caster Installation

CASTER LEVELING

INSTRUCTIONS (Continued)

6.Reinsert each bolt through its flatwasher and the fryer mounting bracket; next, place a spacer of the required size on the bolt before inserting the bolt through its mounting hole on the caster mounting plate and screwing a locking nut onto the bolt.

7.Repeat step 6 for all remaining bolts.

8.Tighten all four locking nuts evenly and se- curely against the caster mounting plate and the fryer bottom mounting bracket.

9.Return the fryer to its desired location. Lock the front casters to prevent fryer movement and check again for wobbling or rocking. Repeat steps 3 through 9 until no wobbl- ing or rocking occurs. When the fryer no longer wobbles or rocks, perform step 10.

10.Perform the Fryer Restraining Device

Installation Instructions, referring to Figure 2.

9