INSTALLATION REQUIREMENTS
Install the fryer in accordance with the preceding Code Requirements, as well as the following Installation Requirements.
1.DO NOT install this fryer in a mobile home, trailer, or recreational vehicle.
2.Install this fryer in a location that has the fryer’s electrical receptacle nearby (5 feet or less away) to avoid straining the fryer’s power cord. (See Figure 2.)
3.Install this fryer in a location that allows it to be moved away from other adjacent appliances for cleaning and maintenance.
NOTE: If the fryer is installed among a row of appliances (“banked”), with its only convenient movement forward, sufficient room must be available in front of the fryer to permit its separa- tion from adjacent appliances for cleaning and maintenance.
4.Tightly fasten the legs (or casters) to the bot- tom of the fryer using the supplied hardware, to prevent the fryer from tipping, wobbling or rocking when it is in its desired location. Refer to the following Leg Installation Instructions or Caster Installation Instructions for leg or caster attachment and leveling information.
! | CAUTION: Hood |
| MUST NOT flow in a manner that |
| restricts or impedes the natural flow |
| of combustion or ventilation air. |
|
|
5.Confirm that the air from the ventilation hood flowing near the fryer after installation is NOT blowing on the rear of the unit, to prevent affecting the burner flames and possibly causing
damage to plastic parts.
INSTALLATION INSTRUCTIONS
LEG INSTALLATION
INSTRUCTIONS
1.Flatten the shipping carton (after unpacking the fryer and its parts and accessories) for fryer surface protection during leg installation.
2.Position the side of the fryer flat on the carton, exposing the fryer bottom mounting brackets for leg installation, as shown in Figure 3.
3.Place the leg mounting plate flush against the mounting bracket on the fryer bottom, while aligning the mounting holes.
4.Insert one mounting bolt through a flat washer and then through the proper hole in the fryer mounting bracket and through the leg mounting plate.
5.Screw a locking nut several turns onto the mounting bolt.
6.Repeat steps 4 and 5 until all four mounting bolts for a leg are in place with locking nuts.
7.Tighten the four locking nuts evenly and se- curely to hold the leg mounting plate against the fryer bottom mounting bracket.
7