IMPORTANT SAFETY INFORMATION (continued)
The following warnings and cautions appear throughout this manual and should be carefully observed.
•Turn the unit off, disconnect the power source, and allow unit to cool down before performing any service or maintenance on the unit.
•The equipment should be grounded accord- ing to local electrical codes to prevent the possibility of electrical shock. It requires a grounded receptacle with separate electrical lines protected by fuses or a circuit breaker of the proper rating.
•All electrical connections must be in accor- dance with local electrical codes and any other applicable codes.
•WARNING, ELECTRICAL SHOCK HAZARD. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
-Electrical ground is required on this appli- ance.
-Do not modify the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
-Do not use an extension cord with this appliance.
-Check with a qualified electrician if you are in doubt as to whether the appliance is properly grounded.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agency or a similarly qualified person.
•This equipment is to be installed to comply with the local plumbing code and any other applicable code.
•Water pressure must not exceed the mem- brane burst pressure of 7 bar (100 psi). To reduce water pressure, install a water pres- sure regulator and set the water pressure to suit application. Note that trans membrane pressure (inlet water pressure) must be .5 - 2.5 bar (7 - 36 psi).
4 | P/N 1010852 Rev. C 04/06 |
