Figure F.23

Figure F.23

The MC/S setup instructions are very similar to MPIO, detail steps are in the following figures. For the target side setting, the steps are exactly the same as MPIO. Please refer to Figure F.1 to Figure F.9.

žCreate a VG with RAID 5, using 3 HDDs.

žCreate a UDV by using RAID 5 VG.

žRun Microsoft iSCSI initiator 2.03 and check the Initiator Node Name.

žAttaching LUN to R5 UDV. Input the Initiator Node Name in Host field.

žThe volume config setting is done.

žCheck iSCSI settings. The IP address of iSCSI data port 1 is 192.168.11.229, port 2 is 192.168.12.229 for example.

žAdd Target Portals on Microsoft iSCSI initiator 2.03.

žInput the IP address of iSCSI data port 1 (192.168.11.229 as mentioned in previous pages). For MC/S, there is only ONE “Target Portals” in the “Discovery” tab.

- 112 -

Page 112
Image 112
APC SCSI-SATA II manual Figure F.23