Take Apart | Logic Board - 37 | |
| holes in the back of the |
|
| chassis. Lower the front of | |
| the logic board so that the | |
| pegs in the housing base fit | |
| into the logic board holes. | |
| Press the front edge of the | |
| logic board down until the | |
| release tab clicks. Connect | |
| all cables to the proper | |
| sockets on the logic board. | |
| (See the diagram on the | |
| next page. Two | |
| connectors from the power | |
| supply have no sockets, and | |
| will remain unconnected.) | |
| The LED connector must be | |
| plugged in so that the arrow | |
| goes over pin 1 on the logic | |
