APW Wyott AT/BT Series, M Series manual BUN CHUTE/FEEDER/SUPER Feeder Installation, 83 & M-91

c)Remove Top Front Panel (Item 4A) by gripping rear edge and lifting up. The Bottom Front Panel (Item 4B) can then be removed by holding the top edge with one hand and the bottom edge with the other hand, then lifting panel up.

d)Cut and remove the nylon tie securing the conveyor. (Note: to remove for cleaning, see "Disassembly" instructions.)

e)Replace Bottom and Top Front Panels (Items 4A & 4B), Butter Pan (Item 3) and Butter Roller (Item 2).

4.BUN CHUTE/FEEDER/SUPER FEEDER INSTALLATION

M-83/M-83D:Install Bun Chute/Feeder (Item 7) by fitting slots on each side onto back panel studs

located at top rear of unit. .

M-91:Install Feeder/Super Feeder (Item 7) by sliding feeder support "legs" into channels

located at top rear of unit.

5.INSTALLATION OF OPTIONAL TEFLON SHEET FOR DRY OPERATION AND/OR INCREASED EASE OF CLEANING

NOTE: Apply light coating of oil to grill surface prior to installation of Teflon sheet.

M-83 & M-91

a)Lay Teflon Sheet on flat surface. Measure approximately 2" from end of sheet. Notch corners as needed. Fold under 2" long flap. Crease Teflon Sheet at 2" fold.

b)Remove Super Feeder (bun chute). From rear of Teflon Sheet retainer bracket, slip 2" fold of Teflon Sheet under bracket. Bring balance of sheet forward and smooth sheet down against grill plate.

c)Reinstall Super Feeder bun chute.

M-83 & M-91

Teflon Sheet

Teflon Sheet

Retainer Bracket

Grill

Plate

M-95

a)Slide one' end of teflon sheet beneath conveyor to bottom of grill plate.

b)Place other end of teflon sheet over top edge of grill plate.

c)Install teflon sheet retainer over teflon sheet and grill plate.

M-95

M-83 Teflon Sheet Kit P/N 87449 M-91 Teflon Sheet Kit P/N 83764

M-95-2 Teflon Sheet Kit P/N 84177 M-91-3 Teflon Sheet Kit P/N 84176

5