8e6 ThreaT analysis reporTer Quick sTarT Guide 19
install the server

Step 1: Initial Setup Procedures

This step requires you to link the workstation to the Threat Analysis Reporter. You have
the option of using the text-based step-by-step setup procedures described in Step 1A.

Step-by-Step Setup Requirements

Threat Analysis Reporter unit with AC power cord
either one of two options:
PC monitor with AC power cord and keyboard, or
PC laptop computer with HyperTerminal and serial port cable (and USB DB9 se-
rial adapter, if there is no serial port on your laptop)
NOTE: Before installing the Threat Analysis Reporter server, the R3000 server
to be used with this server must already be installed and running software version
2.0.10 or higher.
Go to Step 1A to execute Step-by-Step Setup Procedures.

Step 1A: Step-by-Step Setup Procedures

Link the Workstation to the Threat Analysis Reporter

Monitor and Keyboard Setup
A. Connect the PC monitor and keyboard cables to the rear of the chassis (see Fig. 1).
B. Turn on the PC monitor.
C. Power on the Threat Analysis Reporter by dropping down the face plate and pressing
the large button at the right of the front panel (see Fig. 2).
Once the Threat Analysis Reporter is powered up, proceed to the Step-by-Step Initial
Setup Procedures instructions.
•
•
•
•