Argee MSA-004-004 quick start Install the Ethernet Tap Unit

Tap Installation

Install the Ethernet Tap Unit

Diagram showing TAR Ethernet Tap installation on the network

This step is a continuation from Physically Connect the Unit to the Network in Step 1A or following setup in Step 1B. The procedures outlined in this step require the use of a CAT-5E cable.

A.Provide power to the Ethernet Tap by connecting both power cords from the unit to the power source.

AC power in rear panel of NetOptics 10/100BaseT Tap

B.If a designated source R3000 (to be used with the Threat Analysis Reporter) is al- ready installed on the network, disconnect the cable that connects this R3000 to the switch.

If the designated R3000 has not yet been installed, disregard this sub-step and pro- ceed to sub-step C.

52 8e6 Threat Analysis Reporter Quick Start Guide