Powering on the Switch
Powering on the Switch
This section describes how to apply power to the FriendlyNet FS4000E Series Switches.
◆Note: This applies to the Uplink Port after powering on the Switch. If you are unsure of your cable type (straight- through or crossover) and the Link LED associated with the port is not on, try pressing the Uplink button again.
FS4002E and FS4004E
The FS4002E/FS4004E Switches may be turned on with (or without) LAN segment cables connected. To power on the Switch:
1 Connect one end of the power cord (supplied) into the 12Vdc power connector on the back panel of the Switch.
▲Important: Make sure the power supply that was packaged with your FriendlyNet Switch is matched with the line volt- age used in your area.
2 Plug the 12Vdc power supply into an AC power outlet.
◆Note: There is no power switch on the FS4002E or FS4004E. These switches are automatically powered on as soon as the power cord is connected between the Switch and the power outlet.
FS4008E and FS4016E
The FS4008E/FS4016E may be turned on with (or without) LAN segment cables connected. To power on the Switch:
1 Connect one end of the power cord (supplied) into the AC power connector on the back panel of the Switch.
◆Note: The FS4008E and FS4016E are equipped with an internal power supply. Power sensing is automatic for all international utility power.
◆Note: There is no power switch on the FS4008E or FS40016E. These switches are automatically powered on as soon as the power cord is connected between the Switch and the power outlet.
2 Connect the power cord to a local power source outlet.
Page
