7.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default , the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5K/EPU

+5VSB MB

Chassis Signal GND

CHASSIS (Default)

P5K/EPU Chassis intrusion connector

8.ATX power connectors (24-pin EATXPWR, 4-pin ATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

P5K/EPU

ATX12V

+12V DC +12V DC

GND GND

EATXPWR

+3 Volts Ground

+12 Volts +5 Volts

+12 Volts +5 Volts

+5V Standby +5 Volts

Power OK -5 Volts

Ground Ground

+5 Volts Ground

Ground Ground

+5 Volts PSON#

Ground Ground

P5K/EPU ATX power connectors

+3 Volts -12 Volts

+3 Volts +3 Volts

2-30

Chapter 2: Hardware information

Page 54
Image 54
Asus P5K/EPU manual Chassis intrusion connector 4-1 pin Chassis, ATX power connectors 24-pin EATXPWR, 4-pin ATX12V