Asus P5K/EPU manual Internal connectors, Floppy disk drive connector 34-1 pin Floppy

2.7.2Internal connectors

1.Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

P5K/EPU

FLOPPY

PIN 1

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

P5K/EPU Floppy disk drive connector

2.IDE connector (40-1 pin PRI_E IDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray. Connect the blue connector to the motherboard’s IDE connector, then select one of the following modes to configure your device.

P5K/EPU

P5K/EPU IDE connector

PRI_EIDE

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

Drive jumper setting	Mode of	Cable connector
	device(s)

Single device	Cable-Select or Master	-
Two devices	Cable-Select	Master
		Slave
	Master	Master
	Slave	Slave

Black

Black

Gray

Black or gray

2-26 Chapter 2: Hardware information