1.
CLOCK
The system will announce the current clock setting.
2.Press and hold
CLOCK
The system will announce the current day setting, then announces "To change, press SKIP or REPEAT , to change the hour, press CLOCK."
3.
SKIP or
REPEAT
until the system announc- es the correct day, then press CLOCK.
4.
SKIP or
REPEAT
until the system announces the correct hour, then press
CLOCK.
5.
SKIP or
REPEAT
until the system announces the correct minutes, then press CLOCK.
6.
SKIP or
REPEAT
until the system announc- es the correct year, then press CLOCK. The system announces the current clock setting.
Answering system operation
Day & time announcements
To set day and time
Before playing each message, the answering sys- tem announces the day and time the message was received.
Before using the answering system, follow the steps on the left to set the day and time, so mes- sages are dated correctly. If the clock is not set, before playing messages, the system will prompt "Power failure" each time.
To begin, press and hold the CLOCK button for two seconds.
The system uses voice prompts to guide you. Each time you press 
SKIP or 
REPEAT , the day, hour, minute or year increases or decreases by one. When you hear the correct setting, press CLOCK to move to the next setting.
To check day and time
You can press CLOCK at any time to listen to the current day and time without changing it.
NOTES:
1.The answering system must be on to review or change settings.
2.Caller ID provides the time and date. Set the year so that the day of the week can be calcu- lated from the caller ID information. After you set the time once, it will always be set auto- matically with incoming caller ID information. The time will be set automatically only if you subscribe to caller ID service provided by your local telephone company (page 15).
21
