AT&T MLS-6TM, MLS-12DTM manual Dial Mode Line, Dial Mode L8 1 Touch Tone, Dial Mode L8 2 Rotary

Dial Mode	Code: #201
	Description: Identifies each outside line as either touch-tone or rotary.
	Valid Entries:	✓ 1 = Touch-tone line
		2 = Rotary line
	Considerations: If you are using touch-tone phones on rotary lines, you may
	need to adjust the Rotary Dialing Timeout (#108).
	Programming	Steps:

1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 2 ] [ 0 ] [ 1 ] . The display reads:

Dial Mode

Line:

2. Enter the first line to be programmed. For example, to program line 8, press [ 8 ] . The display reads:

Dial Mode L8

1 Touch Tone

3. To change the dial mode, press [ Next Data ] . The display reads:

Dial Mode L8

2 Rotary

To program another line, press [Next Item] or [ Prev Item ] until the correct line number shows on the display. Follow step 3 to change the dialing mode. Repeat for all lines that you want to change.

✓ = Factory Setting

To go to the next procedure: [Next Proc ]	To go to a specific procedure: [ # ] [ 2 ] [ 0 ] [ 1 ] . The
To go to the previous procedure: [ Prev Proc ]	(where XXX is the procedure number)
To return data to the factory setting: [ Remove ]	To exit system programming: [Feature ] [ 0 ] [ 0 ]

System Programming 3-9