Doorphone
Alert
Extensions
Code: #606
Description: Identifies the extension or extensions that ring when someone presses the button on a doorphone. Each doorphone can have up to five alert extensions. The doorphones can have five individual alert extensions or they can share alert extensions. Use procedures #604 and #605 (Doorphone 1 and Doorphone 2 Extensions) to assign doorphone extensions.
Valid Entries: ✓ 1 = Not an alert extension
2 = Doorphone 1 alert extension
3 = Doorphone 2 alert extension
4 = Both doors alert extension
Programming Steps:
1.Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 6 ] [ 0 ] [ 6 ]. The display reads:
DoorPhneAlert
Extension:
2.Enter the first alert extension. For example, to select extension 10, press [ 1 ] [ 0 ]. The display reads:
DoorPhneAlert 10
1 No Alert
3.To change the alert status, enter the appropriate setting as listed above. For example, to make this extension an alert for both doorphone exten- sions, press [ 4 ] . The display reads:
DoorPhneAlert 10
4 Doors 1 and 2
To select another alert extension, press [ Next Item ] or [ Prev Item ] until the extension number shows on the display. Repeat step 3.
IMPORTANT: If you press [ Next Proc ] , the system skips procedure #728, Sys- tem
To use procedure #728 at this point, you must enter [ # ] [ 7 ] [ 2 ] [ 8 ] .
✓ = Factory Setting
To go to the next procedure: [ Next Proc ] | To go to a specific procedure: [ # ] [ x ] [ x ] [ x ] |
| |||
| |||||
| |||||
To go to the previous procedure: [ Prev Proc ] | (where XXX is the procedure number) |
|
|
| |
To return data to the factory setting: [ Remove ] | To exit system programming: [Feature ] [ 0 ] [ 0 ] |
| |||
|
|
|
|
|
|
System Programming
