To insert the button designation card on your telephone
1If you are using a new telephone, remove the button designation card from the box in which the telephone was shipped
2In the blank space next to the appropriate programmable dialing button, write or type the name or telephone number you want to store
3Fold along the perforated edge(s) and detach the card(s) from the sheet
4Remove the plastic cover by placing your finger in the finger slot on the right side of the telephone and lifting up
5Place the designation card on the telephone. Replace the plastic cover over the designation card by fitting the cover’s bottom tabs into the slots on the telephone and pressing down, allowing the tabs on the top to snap into place
To program any of the 12 programmable dialing buttons (while
1Press the PROGRAM button to enter programming mode
●You hear a low continuous tone while you are in programming mode
2Press programmable dialing button on which you want to store the number
●Tone is briefly interrupted twice
3Dial number you want to program on the button. You can use up to 20 elements (digits and characters, including Pause and Flash)
●The tone to remind you that you are in programming mode is interrupted at each time
you press a dial pad key, the PAUSE button or
[ Flash ]
●You hear a rapid error tone if you try to enter more than 20 elements
●You can use the PAUSE button to program a
18
