Answering system
NOTE: If the clock is
not set when a message is recorded, the system will announce, "Time and day not set" before the message is played.
Day & time announcement
Before playing each message, the answering system announces the day and time the message was received.
If you subscribe to caller ID service from your local telephone company, the time will automatically be set with every incoming call. You must set the year so that the day of the week can be calculated from the caller ID information.
To check day & time
You can press CLOCK when the system is idle to hear the current day and time.
If you do not hear the correct year, time and day, follow the steps below.
To set day & time
Follow the steps below to set the year, time and day, so the day and time are correct. Each time you press 
SKIP or 
REPEAT, the year, hour, minute or day is adjusted by one. Press and hold 
SKIP or 
REPEAT to adjust the minutes or year by increments of ten. When you hear the correct setting, press CLOCK to move to the next setting.
1.Press CLOCK. The system will announce the current clock setting, and then announce “To set the clock, press CLOCK.”
2.Press CLOCK. The system will announce the current year setting, and then announce “To change the year, press SKIP or REPEAT. To change the hour, press CLOCK.”
3.Press CLOCK. The system will announce the current hour setting, and then announce “To change the hour, press SKIP or REPEAT. To change the minute, press CLOCK.”
4.Press CLOCK. The system will announce the current minute setting, and then announce “To change the minute, press SKIP or REPEAT. To change the day, press CLOCK.”
53
