ATTO Technology 3400

Secure Data Path Applicationv 4

Exhibit 2-2 Dual-zone configuration (Zone 2 and Zone 3). Each zone is independent of the other, and so may be

configured to run at different or the same speed: 1 Gigabit or 2 Gigabit. Ports 2, 3 and 4 may access port 1, but only

one at a time, under control of the Command Line Interface Setup and Switch commands. Ports 6, 7 and 8 may access

port 5, but only one at a time under control of the Setup and Switch commands.

Port 1 Port 2 Port 3 Port 4 Port 5 Port 6 Port 7 Port 8

Disk array

Host

Disk array

Zone 3Zone 2

Host HostHost Host Host

Contents

Main Page Page Contents Page 1 Fibre Channel is a key technology for storage Glossary Page 2 ATTO FibreCenter supports diverse SAN needs Quick start instructions Page 3 ATTO FibreCenter 3400 characteristics Page 4 Setting up the FC Rack System Page 5 Setting up the ATTO FibreCenter Change in password is effective immediately. Installing the FibreCenter To change the password Connecting Fibre Channel ports Removing the FibreCenter 6 Configuring the ATTO FibreCenter Page 7 Command Line Interface use and guidance Page 7.1 Ethernet and Telnet configuration commands Default Router Default: 0.0.0.0 Echo Factory 7.2 Diagnostic commands Status Telnet Status Versio n BEGFDCA 7.3 Configuration commands Flush, Setup and Switch commands are all closely related. Flush Rate Page 8 Updating firmware Flash File System (FFS) Update 9 Troubleshooting Index: Command Line Interface Command Default Example Page Appendix A Standards and compliances UL 1950 3rd Edition FCC Standards: Radio and Television Interference Canadian Standards European Standards: Declaration of Conformity Appendix B Contact ATTO Technology, Inc.