15
ATTO FibreCenter 3400
Ins
tallation and Operation Manual
7.1 Ethernet and Telnet configuration commands

Configure the ATTO FibreCenter 3400 using a Telnet session over the Ethernet port. The commands in

this section configure or provide information about the Ethernet port and the Telnet session.

Default Router

Sets a new default router address for the Telnet server. Set the default router within the subnet as defined by the subnet mask and IP Address.
Limit: 0-255

Default: 0.0.0.0

Action:
set•RACK •000•Default•Router•[n.n.n.n]
Information:
get•RACK •000•Default•Router
reset•rack•000
or power cycle

Echo

Sets the Telnet command echo mode.
Limits: [on|off]
Action:
set•RACK •000•Echo•[on|off]
Information:
get•RACK •000•Echo
reset•rack•000
or power cycle

Factory

Defaults

The Telnet parameters are set to their factory default values.
Action:
set•RACK •000•Factory•Defaults
Information: none
reset•rack•000
or
power cycle

Idle Timeout

Sets time period in seconds after which, if ther e is no action on the Telnet port, the Telnet session is shut down.

Default: 60 minutes

Action:
set•RACK •000•Idle•Timeout•[n]
Information:
get•RACK •000•Idle•Timeout•[n]
reset•rack•000
or
power cycle

IP Address

Sets a new IP address which will be used after next reset.
Limit: 0-255 Default: 192.168.1.1
Action:
set•RACK •000•IP•address•[n.n.n.n]
Information:
get•RACK •000• IP•Address
reset•rack•000
or
power cycle

Security Traps

Sets the Telnet security level

Default: 3

Action:
set•Security•Traps•[n]
Information:
get•RACK •000•Security•T r aps
reset•rack•000
or power cycle

Subnet

Mask

Sets a new subnet mask which will be used after next reset.
Limit: 0-255 Default: 255.255.255.0
Action:
set•RACK •000•Subnet•Mask•[n.n.n.n]
Information:
get•RACK •000•Subnet•Mask
reset•rack•000
or
power cycle

Telne t

Ends the current Telnet session and opens another
Action:
Telnet
Information: none

Telnet Status

Returns the Telnet status. The format will be determined in the future.