Initial Setup
Assembling the Turntable
The
1.Carefully place the turntable platter on the center spindle, making certain the platter is fully seated on the spindle.
2.While holding both ends of the red tape ribbon on the turntable belt, carefully pull the belt over the motor pulley (Fig. 2a). (If the belt drops off, remove the turntable platter and put the belt back on it, as described on page 7.)
3.Once the belt is seated in the pulley’s groove, carefully remove the ribbon. Make certain the belt is not twisted.
4.Place the turntable mat on top of the turntable platter (Fig. 2b).
5.If desired, the hinged dust cover may be removed. Hold both sides of the dust cover and pull upward gently and evenly to detach the cover from the turntable (Fig. 2c). Keep the cover in a safe, clean place.
6.To
Connecting to Computers with USB Input
The USB cable (included) connects your
Setting the Pre-amp (Phono/Line) Switch
For increased flexibility of use, this turntable has an internal stereo phono
NOTE: If you are using the USB cable to connect your turntable to a computer, the
Figure 3
PHONO“AUX”
Input
Jacks
Selector
Switch
Figure 2 – Assembling the Turntable 2a – Drive belt
Red ribbon | Motor spindle |
Drive belt
2b – Record mat
2c – Dust cover removal
Stereo System
White
Red
AC
PHONO | LINE | USB |
AC
4