GX2411ci English I/B ver. 09010A-1

1.Remove the battery compartment cover of the handset. Connect the rechargeable Ni-Cd battery as shown on Figure 10.

Handset

 

Battery

Insert the End of the

Compartment

Battery Pack Wire

RED Wire

BLACK Wire

(Figure 10)

2.Insert the Ni-Cd battery into the battery compartment of the handset.

3.Slide the battery compartment cover firmly in its closed position.

INITIAL SETUP

Before you can use your cordless telephone, the handset must be charged for at least 20 hours. See charging instruction on MAXIMIZING BATTERY LIFE section of this manual.

SETTING THE DAY AND TIME OF THE BASE UNIT

NOTE: The time set is used for time stamping the recorded message(s).

1.After 20 hours, lift the handset from the base unit.

2.Press the REMO button on the handset. The GX2411CI

will prompt “You have no new message. For help, press 9.” followed by a long beep. (Figure 11)

3.Press 2. The unit will prompt “Time is off. Enter new day.”

4.After hearing a long beep, enter the new day (Sunday = 1, Monday = 2, Tuesday = 3, etc.). The unit will then prompt “Enter new time.”

5.After hearing a long beep, enter the new hour (01-12).

6.After two beeps, enter the new minute (00-59).

7.After two beeps, press 1 for AM, or press 2 for PM. The unit will announce the new day and time followed by a long beep and will prompt “Please enter next command.”

8.Press the REMO button to exit the remote mode. Otherwise, the remote function will turn off automatically if not in use for 8 seconds.

TONE / PULSE SETTING

 

Select the appropriate dialing service by moving the T / P

 

(Tone / Pulse) switch on the bottom of the base unit:

 

TONE for Tone service, or

T / P

PULSE for Rotary service.

(Figure 12)

SETTING THE HANDSET RINGER

The handset ringer must be set to ring ON position in order that to ring when receiving an incoming call. See PROGRAMMING MODE section on page 26.

SETTING USER'S AREA CODE AND NEIGHBORING AREA CODE

In order to use callback function, the user's area code and neighboring area code must be programmed. Neighboring area code is optional. See PROGRAMMING MODE section on

13

09010A-1

OWNERS MAN # GX2411ci VER. 09010A-1

PAGE: 13

English version

Page 14
Image 14
Audiovox GX2411ci manual Initial Setup, Setting the DAY and Time of the Base Unit, Tone / Pulse Setting