Audiovox GX2411ci manual Erasing ALL Memo Messages, Erasing OGM, From the Extension Phone

GX2411ci English I/B ver. 09010A-1

C. ERASING ALL MEMO MESSAGES
1. In standby mode, press the ERASE button briefly for
less than 2 seconds and press and hold MEMO button
for about 2 seconds.	(Figure 25)

2.The GX2411CI will announce “Message erased. You have no Memo message”.

D.ERASING OGM

1.During OGM playback, press ERASE button.

2.The GX2411CI will announce “Erase your announcement. You have no announcement.”

NOTE: After erasing messages during memory full or near memory full, you may hear a continuous beep for several seconds indicating memory sorting of the unit.

MEMORY FULL DETECTION

The memory full condition occurs:

∙If 15 minutes of recording time is reached, or

∙If 59 messages (i.e. Memo, OGM, ICM) have been recorded.

In this case, the ANS. ON/OFF LED indicator will blink in answer on mode. If there is an incoming call, the unit will answer at the 10th ring and announce “Memory full”. You can erase any or all the messages remotely after listening to them. Refer to the REMOTE OPERATION section for more details.

NOTE: Sometimes you may fail to escape from memory full condition when erasing a short message. In this case, you must erase more messages (at least 1 minute message).

CALL SCREENING

You can listen to the caller leave their ICM and decide if you want to answer the call.

A.FROM THE HANDSET (Away From the Base Unit)

1.When the GX2411CI rings, press the REMO button on the handset. The GX2411CI

will immediately answer (Figure 26)the call. You will hear your OGM followed by the caller's message through the handset receiver.

2.If you decide to take the call, simply press the TALK button and begin speaking.

B. FROM THE HANDSET (In the Base Unit Cradle)

1.When the GX2411CI answers a call, you will hear your OGM followed by the caller's message through the base unit’s speaker.

2.If you decide to take the call, simply pick up the handset. Begin speaking and the ICM

recording is stopped. The recorded message is stored in memory and the message count is incremented by one.

C. FROM THE EXTENSION PHONE

1.When the GX2411CI answers a call, you will hear your OGM followed by the caller's message through the speaker.

2.If you decide to take the call, just lift the handset of the extension phone on the same line as the GX2411CI and the ICM recording is stopped. The recorded message is stored in memory while the message count is incremented by one.

TWO-WAY RECORDING

Two-Way Recording allows you to record your conversation with another caller. Two-Way Recording can be enabled during TALK mode while you are using the handset. Two-Way Recording(s) is stored in Message (MSG) box.

1.While in TALK mode, press and hold the PAGE / 2- WAY REC button of the base.

2.Release the PAGE / 2-WAY REC button to

end your Two-Way recording.	(Figure
28)
09010A-1	20
OWNER’S MAN # GX2411ci VER. 09010A-1
PAGE: 20	English version