14 | Installation (for qualified installers only) |
Electrical Line Connection
1/4" Nutdriver
| b | Insert the sheathed cable from the power source through | |
| this cable clamp. Once the wires are attached, tighten | ||
a | Remove the cover | ||
the clamp to secure the cable. | |||
from the fireplace | |||
| |||
| junction box. |
| |
| Electrical |
| |
| Connector |
| |
|
| Standard | |
|
| Screwdriver |
WARNING: Make sure power is off from the power lead before conducting any wiring.
c | Attach the common (white), ground (exposed or green) | Replace the | |
wires, and hot (black) wires from the power source to the | d cover removed | ||
| |||
| electrical connector (attached to the fireplace). | in step "a". |
Optional Electrical Line Location
a | Remove the cover plate on the bottom of the |
fireplace (save these nuts). |
b | Remove the two screws securing the | |
electrical inlet (save these screws). | ||
|
Position the cover plate over the c electrical inlet hole on the right side
of the fireplace and secure using the nuts removed in step “a”.
Position the electrical inlet assembly over the d hole in the baseplate of the fireplace and
secure using the screws removed in step “b”.
© Travis Industries | 4040830 |
