4610 and 5610 User Guide
4610 and 5610 User Guide Page 34
IP Office 3.2 [15-601080] Issue [3] (5 June 2006)
Longhand Programming
1. Press Admin or Admin 1.
2. To switch to longhand programming mode, press Expl? .
3. Press Next until the function required is shown, then press Selct .
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter
the data using the normal phone keypad.
5. The upper part of the display reverts to showing the functions currently assigned to each and
.
6. To move between the pages of display keys, press and .
7. To select the display key against which to program the new function, press or .
Caution
Do not select the slot used for the Admin function. Replacing this function will lock the
phone for further programming until reset through the phone system.
8. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
To end programming, press Phone/Exit.
To continue programming other functions, press Cont
9. If the display slot already has a programmed function, the display shows FEATURE ON
BUTTON. Press or until Repla, Keep and Delet are shown along the right-hand edge of the
display.
To replace that existing function with the one just programmed, press Repla .
BUTTON PROGRAMMED! is displayed.
To keep the existing function and forget the function just programmed, press Keep .
To delete the existing function and forget the function just programmed, press Delete .