ExpertNet Lite Assessment Tool - User Guide
TProtocolSelect a traceroute protocol to be used to discover intermediate routers on
To Endpoint | Select an endpoint to which the RTP test is to be created. If Traffic |
| Simulators are connected and registered with the Controller, they will |
| be available in the |
|
|
Codec | Defines the Codec of the RTP test calls. This will alter the rate and size |
| of packets being sent between Traffic Simulators in order to emulate |
| the G.711 and G.729 codecs. |
|
|
Diff Serv Code Point | Defines the Differentiated Services Code Point (DSCP) of the IP Packets |
| of RTP test calls. Routers will treat packets differently depending on the |
| DSCP value set in outgoing packets. By default this value is 46 |
| (Expedited Forwarding). |
|
|
Voice Payload Size | Defines the Voice Payload size of the RTP packets of a test call (in |
| milliseconds). Must be a multiple of 10. |
|
|
Number of | Number of equivalent VoIP calls for a selected codec in a single test. |
Simultaneous Calls | The default value for this setting is 2. Measurements for each call can |
| only be taken in one direction. When two or more calls are configured, |
| half of them originate at the Controller and half at the test agent so |
| data is collected in both directions providing a more complete |
| assessment of the network than if a single call were run. |
|
|
Test Duration | Defines the duration of each RTP test call (in seconds). |
|
|
Discover Path | Check this button if you want the Controller to discover intermediate |
| routers on the path to the endpoint. |
|
|
Protocol | Select a traceroute protocol to be used to discover intermediate routers |
| on the path to the selected endpoint. |
|
|
SNMP Polling | Check this button if you want the Controller to collect SNMP statistics |
| for devices on this path. |
|
|
17