10AXIS 210/210A/211/211A - Accessing the Camera
Setting the Password
1.When accessing a camera for the first time, the ‘Configure Root Password’ dialog will be displayed on the screen.
2.Enter a password and then
3.The ‘Enter Network Password’ dialog will appear. Enter the User name: root
Note: The default administrator user name root is permanent and cannot be deleted.
4.Enter the password as set in step 2 above, and click OK. If the password is lost, the cameras must be reset to the factory default settings. See page 46.
5.If required, click Yes to install the AXIS Media Control (AMC). You will need administrator rights on the computer to do this.
Accessing the camera from the Internet
Once installed, a camera is accessible on your local network (LAN). To access the camera from the Internet you must configure your broadband router to allow incoming data traffic. For security reasons this is usually done on a specific port. Please refer to the documentation for your broadband router for further instructions.
For more information, please visit the AXIS Internet Dynamic DNS Service at www.axiscam.net or, for Technical notes on this and other topics, visit the Axis Support Web at www.axis.com/techsup
Focusing
To focus the AXIS 210/210A, simply turn the adjustment ring on the lens until the focus is satisfactory.
To focus the AXIS 211/211A, follow the instructions below.
1. From the Basic Configuration pageAXIS 211/211A in the setup tools, open the Focus
adjustment page.
2. Set the | Focus puller |
Save. |
|
3.Unscrew the zoom puller on the lens by turning it
4.Unscrew the focus puller on the lens. Adjust the focus as required.
5.From the Focus adjustment page, set the
Note: The