Axis Communications 211a user manual LED Indicators, 8AXIS 210/210A/211/211A - Introduction

8AXIS 210/210A/211/211A - Introduction

Power Connector - For connection of the PS-K power adapter (included).

I/O Terminal Connector - The I/O terminal connector provides the physical interface to one transistor output, one digital input and an auxiliary connection point for DC power. For more information, see The I/O Terminal Connector, on page 47.

Network Connector - The camera connects to the network via a standard network connector. The camera detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). This socket can also be used to power the AXIS 210A and the AXIS 211/211A via PoE (Power over Ethernet).

Audio Output - Audio output (line level), which can be connected to a public address (PA) system or an active speaker with a built-in amplifier. A pair of headphones can also be attached. A stereo connector must be used for the audio out.

External Microphone/Line Input - One 3.5mm input for a mono microphone, or for line-in mono signal (only the left channel is used from a stereo signal).

Serial Number - This number is used during installation.

Control Button - Press this button to install using the AXIS Internet Dynamic DNS Service (see page 41) or to restore the factory default settings, as described in Resetting to the Factory Default Settings, on page 46.

LED Indicators

After completion of the startup and self test routines, the multi-colored Network, Status, and Power LED indicators show as follows:

Network	Amber	Steady for connection to 10 Mbit/s network. Flashes for network activity.
	Green	Steady for connection to100 Mbit/s network. Flashes for network activity.
	Unlit	No wired network connection.
Status	Green	Shows steady green for normal operation. Can be configured to flash green at intervals
		whenever the camera is accessed. See the online help for more information.
	Unlit	When configured for “no flash” on camera access.
	Amber	Steady during startup, reset to factory default or when restoring settings.
	Red	Slow flash for failed firmware upgrade.
Power	Green	Normal operation.
	Amber	Flashes green/amber during firmware upgrade.