44AXIS 210/210A/211/211A - System Options
Network - UPnP™
The cameras includes support for UPnP™, which is enabled by default. If also enabled on your computer, the camera will automatically be detected and a new icon will be added to “My Network Places.”
Note: UPnP must also be enabled on your Windows XP or ME computer. To do this, open the Control Panel from
the Start Menu and select Add/Remove Programs. Select Add/Remove Windows Components and open the Networking Services section. Click Details and then select UPnP as the service to add.
Network - RTP / MPEG-4
These settings are for the IP addresses, port numbers, and
Ports & Devices
I/O Ports - the pinout, interface support and the control and monitoring functions provided by this connector are described in The I/O Terminal Connector, on page 47.
LED Settings
The Status indicator LED on the front of the camera can be set to flash at a configurable interval (or to not light up at all) whenever the unit is accessed. For a listing of all LED behavior, see page 8, or the online help.
Note: The LED does not flash when the stream is retrieved using
Maintenance
•Restart - The camera is restarted without changing any of the settings. Use this method if the unit is not behaving as expected.
•Restore - The unit is restarted and most current settings are reset to factory default val- ues. The settings that will not be reset are as follows:
•the boot protocol (DHCP or static)
•the static IP address
•the default router
•the subnet mask
•the system time
•Default - The default button should be used with caution. Pressing this will return all of the camera's settings (including the IP address) to the factory default values.
Upgrade Server - See Upgrading the Firmware, on page 54.
