1030H | Start pattern number | 0 | ~ 7 | |
1040H~ | Actual step number setting inside the | 0 | ~ 7 = N, indicate that this pattern is executed from step 0 to step N | |
1047H | correspond pattern |
|
| |
1050H~ | Cycle number for repeating the | 0 | ~ 99 indicate that this pattern has been executed for 1 ~ 100 times | |
1057H | execution of the correspond pattern | |||
0 | ~ 8, 8 indicates the program end. 0~7 indicates the next execution pattern number after executing | |||
1060H~ | Link pattern number setting of the | |||
1067H | correspond pattern | the current pattern | ||
2000H~ | Pattern 0~7 temperature set point |
|
| |
203FH | setting; Pattern 0 temperature is set to | |||
| 2000H~2007H |
|
| |
2080H~ | Pattern 0~7 execution time setting | Time 0 ~ 900 (1 minute per scale) | ||
20BFH | Pattern 0 time is set to 2080H~2087H | |||
6.Address and Content of Bit Register: ( First bit of reading will put into LSB, Write data = FF00H for bit set, 0000H for bit clear)
0810H | Communication | Communication write in disabled: 0 (default), Communication write in enabled: 1 |
|
| oC / linear input (default) : 1 , oF : 0 |
0811H | Temperature unit display selection | |
0812H | Decimal point position selection | Except for the thermocouple B, S, R type, all the other thermocouple type are valid. (0 or 1) |
0813H | AT setting | OFF: 0 (default), ON : 1 |
0814H | Control RUN/STOP setting | 0: STOP, 1 : RUN (default) |
0815H | STOP setting for PID program | 0: RUN (default), 1: STOP |
control | 0: RUN (default), 1: Temporarily STOP | |
0816H | Temporarily STOP for PID program | |
control | 0: w/o feedback (default), 1: feedback function | |
0817H | Valve feedback setting status | |
0818H | 0: Stop AT (default), 1: Start AT |
7. Communication Transmission Format : Command Code: 02: read N bits, 05: write 1 bits, 03: read N words, 06: write 1 words
9
