The OIT is connected to the mounting plate with four #6-32UNC screws. The
lengthof the mounting screws is equal to the plate thickness plus 1/4 inch.
NOTE: Themounting screws must not be torqued to more than 18 pound-inches.
Over-torquingcan strip the threads in the enclosure.
3.3. Benchtop Mount
TheMAP450D’s rear cover has two legs set at a five degree angle to give the display
andkeypad a sloped front while sitting on a bench. Fourrubber feet are attached to
thelegs to prevent slippage as well as damage to the surface of the bench.
16 MAP450D
1010-0046A,REV 00
0.156 dia. nominal,
MOUNTING
PLATE
5.400 +/-0.015
5.00 nominal
4.600 +/-0.015
6.00 nominal
4 holes(clearance
(1/8" thick min. recommended)
for #6 screws)
PEDESTAL
2 places
2 places
Figure11 Pedestal/Pendant Mounting Plate Dimensions
Figure12 MAP450D Benchtop Mounting