B&B Electronics MAP450D Appendix A (cont) Dimensional Outline

1 20

Appendix A (con’t)Dimensional Outline

INSTALLATIONMANUAL 19

1010-0046A,REV 00

5.75

[146]

Dimensionsare in inches

[

]

5.00

[127]

0.90[23]

depthbehind the

frontof a panel

8.12[206]

6-32UNCx 0.50 [12.7]

screw, 4placesSS,

6-32UNCx 0.30 [7.6]

deepthreads, for

PedestalMounting only

REAR VIEW

FRONT VIEW

SIDE VIEW,

Free-Standing & Pedestal-Mount

7.10[180]

SIDE VIEW,

Panel-Mount

1.70[43]

overall

Waterproofstrain relief

foroperating cable entry

(Panel)

Contents

Main INSTALLATIONMANUAL COPYRIGHT NOTICE WARRANTY IF SERVICE IS REQUIRED APPLICATIONS ASSISTANCE Read Me First! Introduction CAUTION Static Awareness Unpacking the Unit TABLE OF CONTENTS 1. Control Panel Design Guidelines OIT 1.1. Control Panel Grounding 1.2. Power Supply Selection 1.3. OIT Cable Routing 1.4. Other Steps to Improve Noise Immunity 2. Connecting the MAP450D to a Host Controller STEPS OIT Power Suppl y Host/Controller Heatshrink tubing Chassis shield wire Ferrite coil Connection to communication wires of Host/Controller 2.1. RS-232 (Interactive & Block modes) 2.2. RS-422/485 (Interactive & Block modes) 2.3. RS-422/485 (Network mode) Figure6 5-WireRS-422/485 (Network mode) 10 MAP450D OIT Fromor To Hostor OIT PowerSupply Page Network Termination MAP460D OIT3160 Network Grounding 12 MAP450D 1010-0046A,REV 00 JP4 3. Mounting the MAP450D 3.1. Panel Mount FRONT VIEW 3.2. Pedestal/Pendent Mount 3.3. Benchtop Mount 4. Configuring the MAP450D 4.1. Connecting the MAP450D to a PC OIT PC Power Supply OIT Appendix A OIT Hardware Specifications Appendix A (cont) Dimensional Outline Appendix B Differences Between MAP450D and MAP450B