båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
3.Rack mount processor #4.
4.Connect Ethernet from processor #4 to the Ethernet Switch.
5.Source Connections — connect DVI outputs from processors one, two and three to processor #4’s scaler inputs:
~Connect processor #1 DVI Program 2 output to processor #4 input 1A.
~Connect processor #1 DVI Preview 2 output to processor #4 input 1B.
~Connect processor #2 DVI Program 2 output to processor #4 input 2A.
~Connect processor #2 DVI Preview 2 output to processor #4 input 2B.
~Connect processor #3 DVI Program 2 output to processor #4 input 3A.
~Connect processor #3 DVI Preview 2 output to processor #4 input 3B.
Note | Program 2 output is used because it is a clean feed, without |
| any edge feathering or data doubling in the signal. |
|
|
6.Output Connections —
~Connect processor #4’s analog or digital Preview Output to the input of your widescreen preview monitor.
~(Optional, for video recording) Connect processor #4’s analog or digital Program Output 1 or 2 to the input of the ImagePRO. Connect the ImagePRO’s output to the input of your recorder. Refer to the “ImagePRO User’s Guide” for connection and setup details.
7.Power Connection — connect AC power cords to the AC Power connectors on the rear of processor #4, the monitor and the ImagePRO.
8.System ID — Using the Unit ID Selector, set the ID of processor #4 to 4.
Note
Each processor must have a unique ID.
9.Power On — Refer to Chapter 6 of the Encore Presentation System User’s Guide for all power on instructions.
Important
In order to properly configure processor #4 and its Preview output, several important setup steps must be taken at the Controller. For full instructions, in Chapter 3 of the Encore Presentation System User’s Guide, refer to the “Completing Wide Screen Preview Setup” section.
22 |
| Encore VPx Installation Guide • |
|
