Barco MDCC 6130 manual Installation Procedure, Display Controller Installation

Display Controller Installation

Installation Procedure

The following instructions will take you step by step through the installation of the Barco display controller(s) for your BARCO CORONIS FUSION 6MP Display System.

CAUTION – Wear a grounded, protective ESD strap when handling or during installation of the display controller. Electrostatic charges can damage the display controller.

1.If you are not going to use your old graphics card, uninstall the drivers and software for it if you have not already done so.

2.Turn off the computer, display(s), and other peripheral devices.

3.Unplug the computer’s power cord and disconnect all cables from the back of your computer.

Caution – Wait approximately 20 seconds after unplugging the power cord before disconnecting a peripheral or removing a component from the motherboard to avoid possible damage to the motherboard.

4.Remove the computer cover.

If necessary, consult your computer’s manual for help in removing the cover.

5.If necessary, unscrew or unfasten and remove any existing graphics card(s) from your computer.

Note: If you are using a motherboard containing an on-board graphics solution and do not intend to use it as part of a multiple-display setup, disable it either in the computer’s System Set-up utility (BIOS) or the Windows device manager.

6.Locate the appropriate slot and, if necessary, remove the metal back-plate cover(s).

24