Barco MDCC 6130 manual Turning on your system, Display Controller Installation

Display Controller Installation

DualLink Dongle - for color 3mp or higher (ex: MDCC-6130). Must be ordered separately, part number B560602. Firmware v1.07 or higher required.

11.Reconnect any cables you have disconnected and plug in the computer’s power cord.

12.Turn on the display(s) and then your computer.

Turning on your system

WARNING - Turn on your display(s) before you turn on your computer. Failure to do so could damage your dis- play(s).

If you have properly installed your graphics card, the Windows start-up messages will appear once the boot procedure is finished.

Note: Your Barco display(s) will be running in a basic video mode at a default refresh rate. Higher resolutions and refresh rates, such as 1536x2048@60Hz, are not available at this stage of the installation. Once you have installed the Barco Coronis Fusion 6MP Display System drivers and software, the Barco monitor Plug and Play software should automatically set the resolution for the displays.

28