Barco R5976519/00, R9806700 13.3 File identification

13. Input Source File Ser vice

Intheloadfilemode,theactivefileisindicatedbesidetheitemActiveFile.

When scrollingthrou ghthe files, the image will be adapted according the file specifications of that selected

file.

Ifthe created file doesn’t results in a perfect image, go to the fileedit menu which allows to adap t some parameters (see further).

13.3 File identification

When selectingthe respective input slot with the new source, the horizontal period, the total number of vertical lines and the inter-

lacedmode are automatically measured and filed in the menu table as a new custom file.

Whenediting a custom file, NEVER adjust the autom aticallymeasured valuesas they are used to identify the

inputs ource filewhe nselecting.

Menu Item Explanation

HorizontalTotal Pixels Ifthe value for ’Horizontal Total pixels’ is wrong, sampling mistakes, small vertical bars will be seen

inthe image (Total numbers of pixels between 2 sync pulses is used to adjust the sampling rate).

Select’Total’ and increase or decrease the pixel quantity for no bars in the image. (image 13-1)

Active pixels The’Active pixels’ determine the width of the window on the screen. This value is normally given in

thesource specifications. If not,adjust until full image is displayed (no missing pixels). (image 13-1)

Horizontalstart This is thenu mberof the pixels between the beginning of the input signal and the start of the

videoinform ationin the signal. (image 13-1)

HorizontalPeriod Thisis already filled in with the correct value at thetime of the sou rceidentifying.

VerticalTotal Lines Thisis already filled in with the correct value at thetime of the sou rceidentifying.

ActiveLines Thisis the number of horizontal lines determining the height of the projected image. This value is

normallygiven in the specification of the source. Ifnot, adjust until full image height is displayed (no

missing lines).

VerticalStart This is the number of the lines between the start of the input signal and the start of the image

on the screen.

Interlaced[On] or [Off] This selection is automatically filledat source identifying. If he image is wrong, due to wrong

measurements, use the ENTER key to toggle between On and Off. (For interlaced images, 1

frame contains 2 fields).

Read AMDS AMDS = Automatic Mode Detection & Synchronization

SelectingAMD San dconfirmed with ENTER, the system re-identify the input source.

OptionItem Explanation

SourceNum ber The source number of a non-active source can be changed to any other source number. This makes

itpossible to create a file for future source numbers.

ClampPosition Clampingdetermines the back level of the signal. The clamp pulse can be related to the leading

orthe trailing edge of the synchro pulse. Use the ENTER key to toggle between Leading and

Trailing. (image 13-2)

R5976519 ACSAR 12122002 53