Bay Technical Associates DS4D-RPC, DS2-RPC manual Help, Receptacle Controls

DS-RPC Manual

Enter user name: admin
Average Power:		0 Watts		Apparent Power:	26 VA
True RMS Voltage: 124.7			Volts	Maximum Detected:	0.3 Amps
True RMS Current:		0.1	Amps
Internal Temperature:			25.0 C
Outlet Circuit Breaker:			Good
1)...Outlet	1	:	On
2)...Outlet	2	:	On
3)...Outlet	3	:	On
4)...Outlet	4	:	On

Type "Help" for a list of commands

DS-RPC>help

HELP

Typing ‘Help’ at the DS prompt will display a list of commands to change the state of the outlets, unit configuration, and internal sensor measurements.

On n <cr>		--Turn on an Outlet, n=0,1...4,all
Off n <cr>		--Turn off an Outlet, n=0,1...4,all
Reboot	n <cr>	--Reboot an Outlet, n=0,1...4,all
Status	<cr>	--DS-RPC Status
Config	<cr>	--Enter configuration mode
Lock n	<cr>	--Locks Outlet(s) state, n=0,1...4,all
Unlock	n <cr>	--Unlock Outlet(s) state, n=0,1...4,all
Current <cr>		--Display True RMS Current
Clear <cr>		--Reset the maximum detected current
Temp <cr>		--Read current temperature
Voltage <cr>		--Display True RMS Voltage
Logout	<cr>	--Logoff
Logoff	<cr>	--Logoff
Exit <cr>		--Logoff
Password <cr>		--Changes the current user password
Whoami	<cr>	--Displays the current user name
Unitid	<cr>	--Displays the unit ID
Help <cr>		--This Command

Receptacle Controls

On, Off, Reboot, Lock, and Unlock are commands to control the individual outlets.

From the (DS-RPC >) prompt, enter one of the following commands: ON n, OFF n, REBOOT n, where “n” is the outlet number you want to command.

Example: To turn “On” Outlet 3, type ON 3 from the DS-RPC prompt. The DS responds with:

Turn On Outlet 3 (Y/N)?

Type “Y” for yes turns “On” Outlet 3. Observe the status of Outlet 3 has changed to ‘On’ in the status menu. Likewise, typing ‘ON ALL’, ‘ON 0’, or ‘ON’ at the DS-RPC > prompt and responding “Y” for yes, turns ‘On’ all outlets. The OFF n command work similarly as the ON n command.

12