Connection Description
BayTech's Host communication module determines the type of interface that controls user access to the DS Series data switch and other DS Series connected modules. The Host module is a system data controller that directs operations between this base unit, system modules and externally connected devices.
Installation
UNPACKING
Compare the unit and serial number of the equipment you received to the packing slip located on the outside of the box. Inspect equipment carefully for damage that may have occurred in shipment. If there is damage to the equipment or if materials are missing, contact BayTech technical support at 228-
1.
2.Manual insert describing the location of the User’s Guide on BayTech’s website at www.baytech.net.
3.Power Cords that may be attached to the unit (if order requested detachable cords).
4.1 ea.
5.1 ea.
NOTE: Keep shipping container and packing material in the event future shipment is required.
PREPARING THE INSTALLATION
The installation area should be clean and free of extreme temperatures and humidity. Allow sufficient space behind the DS unit for cabling and receptacle connections. Access to installation site should be restricted to authorized personnel. Installation of these units should be limited to ITE and Telco server environments.
Power
•120 VAC Model: Internal 120 VAC 60 Hz (10 Amps Maximum Load).
•230 VAC Model: Internal 230 VAC 60 Hz (10 Amps Maximum Load).
CAUTION: This unit is intended for indoor use only in a clean and free of extreme temperatures and humidity. Do not install near water or expose this unit to moisture. To prevent heat buildup, do not coil the power cord when in use. Do not use extension cords. Do not attempt to make any internal changes to the power source. Do not attempt to modify any portion or component of a DS72 module unless specifically directed by BayTech Technical Support. BayTech must perform any internal changes.
CAUTION:
5