Belkin F5D5730au user manual Remote Management, Atm Pvc, Parameter, Description, section

Manually Configuring your Modem

Remote Management

By default, management access is only available to users on your local network. However, you can also manage the Modem from a remote host by checking the Enabled check box, and if you wish you can set a HOST ADDRESS, which will only allow that computer to use remote management. The port field should be left as the default setting of 8080

unless you need to change it. After any changes are made you must click on “Save Settings” to apply them.

Note: If you check “Enabled” and specify an IP address of 0.0.0.0, any host can manage the Modem.

For remote management via WAN IP address you need to connect using port 8080. Simply enter WAN IP address followed by :8080 in the address field of your web browser, for example, 123.123.123.123:8080. This applies unless you change the port setting, in which case you need to substitute the 8080 for whatever port you assign.

DNS

Domain Name Servers are used to map a domain name (e.g., www.somesite. com) to the equivalent numerical IP address (e.g., 64.147.25.20). Your ISP should provide the IP address of one or more Domain Name Servers.

If your ISP requires you to manually specify the addresses, enter them on this page.

Manually Configuring your Modem

WAN

Specify the WAN (Wide Area Network) connection parameters provided by your Internet Service Provider (ISP).

ATM PVC

The Modem uses ATM (Asynchronous Transfer Mode) as its WAN interface. Click on each ATM VC for WAN configuration.

See the table below for a description of the parameters.

Parameter	Description
Description	Click on the VC to set the values for the
	connection.
VPI/VCI	Virtual Path Identifier (VPI) and Virtual Circuit
	Identifier (VCI).
Encapsulation	Specifies how to handle multiple protocols at the
	ATM transport layer.
	•	VC-MUX - Point-to-Point Protocol over ATM Virtual
		Circuit Multiplexer (null encapsulation) allows only
		one protocol running per virtual circuit with less
		overhead.
	•	LLC - Point-to-Point Protocol over ATM Logical
		Link Control (LLC) allows multiple protocols
		running over one virtual circuit (using slightly more
		overhead).
Protocol	Protocol used for the connection

1

2

3

4

5

6

7

section

22 23