Belkin UCSPRO-RM2 user manual Parameter & Functions Set-up Guide

Parameter & Functions Set-up Guide

TM

LTO

Refer to the details under Input Equalization - the available parameters are identical.

Pressing NEXT steps through each of the available EQ bands for Output 1, and then Output 2, and so on to Output 6. Press ESC to quit this mode.

Output Gain (Edit Menu): The UCS PRO has no analog output gain controls - gain adjustment is handled entirely in the digital domain. The maximum signal level that can be handled by the D/A converters is 2.2V. Select MODE Edit NEXT x5 Output Gain. Press ENTER.

Now you can set the level for Output 1 (OP1) in 0.5dB steps between 30.0dB and 6.0dB by adjusting the rotary control.

Press NEXT and repeat the procedure above for the other Outputs. Press ESC to quit this mode.

It is important to optimize the Input and Output Gain settings of the UCS PRO to ideally match the output from your car audio head unit and the input stage of your power amplifier(s). The optimum settings will ensure the lowest possible noise and no distortion.

While set-up by ear is possible, the best results will require use of a voltmeter and oscilloscope, and this is therefore generally best left to a professional installer.

Output Polarity (Edit Menu): The signal phase of each output channel can be set at Normal (in phase) or Reverse (180 degrees out of phase).

Select MODE Edit NEXT x6 Output Pol. Press ENTER. Use the rotary control to select Normal or Reverse. Use NEXT to select each Output Channel. Press ESC to quit this mode.

This can be useful for quickly correcting reverse-wired speakers or improving overall phase alignment in multi-speaker installations. This feature becomes especially powerful when combined with the fine control available via the Crossover section, allowing full 360 degree phase adjustment in 5 degree steps.

17