Belkin UCSPRO-RM2 OP1 2k00, EQ1 Pea k 1.0 5.1, +

LTO

Parameter& Functions Set-up Guide

Phase:

OutputPol

Edit OutputEQ

EQType Peak Frequency Bandwidth

Gain

EachOutput channel provides fine control (in 5 degree steps) of the signal's phase. The effect of this

controlis summed with that of the 0/180 degrees Output Polarity ( .)function described a little

furtheron. In this way it is possible to adjust the phase of each individual output through a full 360 degrees.

Whenyou have completed adjustments for Output 1, press NEXT.

Nowyou are presented with the parameters for the High-Pass Filter (HPF) of Output 1 (OP1). Adjust the

settingsin the same way as described for the LPF. Note that there is no Phase adjustment for the HPF.

Pressingthe NEXT key will step through each of the Output Channels, enabling adjustment of the LPF and

HPFfor each one. When you have completed all the settings, press ESC to quit this mode.

Whichfilter settings you should choose will depend largely on the speakers you are using. Since it is

vitalto set-up crossover points carefully to maximise speaker power handling and avoid damaging your

speakers,this is usually best left to a professional car audio installer.

Upto 5 band full parametric equalization is provided on each of the

outputchannels (the exact number of bands will depend on the chosen filter characteristics in the Crossover

section).Frequency, Gain, Bandwidth (Q) and EQ Type can be set independently for each band.

SelectMODE NEXTx4 .Press ENTER.

Youare presented with the parameters for the first of the 5 EQ bands on Output 1 (OP1) - see Fig.4. Use the

arrowkeys to select each parameter: (defaultsetting shows ), , and

.The selected parameter will flash to show it is editable. Adjust the setting by using the rotary control.

NOTE:

OutputEqualization (Edit Menu):

Fig.4

OP12k00EQ1 Pea k1.0 5.1+