Belkin UCSPRO-RM2

LTO

below,indicating that it is an editable parameter. Now you can use the rotary knob to change the value.

Onceyou have set the required value, simply press the ESC (Escape) button. This will take you one level

backup the menu tree.

(3)Your selected value has already been stored. If you now use the MODE button to get you back to the start-

updisplay (press MODE 3 times), you will now see an " "(for Modified) in the start-up display. This warns

youthat the original set-up has been changed. This "modified" status will be retained even if power to the

UCSPRO is switched off. However, you must store your set-up under a new Preset Number before

loadinganother Preset, otherwise your changes will be lost.

Thissame procedure applies to all the options and menus editable via the RM2 Programmer. In some cases

youwill also use the 2 arrow buttons (below PREV and NEXT), where multiple choices are presented on one

screen.

Forexample, using the MODE button select andthen use the PREV or NEXT buttons until you reach

.Press ENTER. The LCD screen now presents you with several options for setting gating on/off,

theattack time and the release time. Use the buttons marked with arrows to select from these various

options.The currently editable parameter will flash and you can use the rotary knob to change the value. If

insteadyou press the NEXT button again, the display will now present you with the options for setting the

gatethreshold and range. Press NEXT again and it will move to the Noise Gate for Input B (unless you have

"ganged"the inputs and the display is showing INA&B GATE - isexplained in detail later in this user

manual).

Whensaving a preset, select MODE NEXT .Select the User Preset number (

indicatesa User Preset) you want to store to by using the rotary control. Press ENTER. You can now name

yournew preset. Press the right arrow button. The first digit of the current name will start to flash. You can

usethe arrow buttons to move along the line. The value of the flashing digit can be changed by turning the

rotarycontrol and selecting one of the letters, numbers or symbols. Then move to the next digit using the

SavingPresets

Edit

NoiseGate

Ganging

Preset StorePreset

EDITINGPARAMETERS USING THE RM2