BenQ VA261 quick start Setup menu, See Performing Manual installation on, Auto, YPbPr

Setup menu

The available menu items are dependent on the input source being selected.

The illustration is for reference only.

Setup

Auto installation

Manual installation

CH swap

Select Adjust OK Enter

Item	Function	Operation	Range
Auto installation Clears both the TV channel list and the sequential channel list, then reloads and
	searches through the designated TV frequencies for available channels, and adds
	any found to the sequential channel list, depending upon the selected country:

•If Australia or New Zealand is selected, this function loads the channel list and searches through the designated TV frequencies for that country, adding any found to the sequential channel list in their proper channel positions.

•If 'Others' is selected as country, searches through all frequencies for the selected PAL TV standard, adding any channels found to the sequential channel list in sequential order starting a position zero.

See "Performing Auto installation" on page 27

Manual	Used for adding channels to the sequential channel list. Allows you to manually
installation	select a channel position in the sequential channel list, and adjust its properties
	including channel frequency.

See "Performing Manual installation" on page 27.

CH swap	Allows you to reorder the channel positions in the sequential channel list, as
	used by the Channel Up and Down buttons.

See "Swapping channels in the sequential channel list" on page 29.

AV 1	Selects the input signal terminal	Press	or	to	• S-Video
	when AV1, AV2 or AV3 is selected as	make selection.			• CVBS
AV 2
	the input. Use these settings only				(composite Video)
	whenever you have more than one				• Auto
	signal type connected to the same
AV 3					• CVBS
	input at the same time.				(composite Video)
	Do not select 'Auto' when more				• YPbPr
	than one signal type is				(Component video)
	connected simultaneously to the				• Auto
	same AV input terminal.
Auto	Automatically adjusts frequency,				• No
	phase, H. position and V. position to				• Yes
	place the image on the screen.
Frequency	Adjusts the display clock frequency.	Press	or	to	0 to 100
		make adjustment.
Phase	Adjusts the display clock phase.				0 to 31
H. Position	Adjusts the horizontal position of				0 to 100
	the image.
V. Position	Adjusts the vertical position of the				0 to 100
	image.

26The On-Screen Display (OSD) menu

Downloaded From TV-Manual.com Manuals