English
Timing of replacing the lamp
When the Lamp indicator lights up red or a message appears suggesting it is time to replace the lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in the projector and in some instances the lamp may explode.
The Lamp indicator light and Temperature warning light will light up if the lamp becomes too hot. See "Indicators" on page 58 for details.
The warning messages below are for reference only. Please follow the actual
Status | Message | |
Install a new lamp for optimal performance. If the | Notice | |
projector is normally run with Economic selected |
| |
(See "Setting Lamp mode as Economic" on page | Order Replacement Lamp | |
53), you may continue to operate the projector | Lamp > XXXX Hours | |
until the next lamp warning appears. | ||
| ||
| Order a new lamp at lamp.benq.com | |
| OK | |
|
| |
A new lamp should be fitted to avoid the | Notice | |
inconvenience when the projector runs out of |
| |
lamp time. | Replace Lamp soon | |
| Lamp > XXXX Hours | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
| |
It is strongly recommended that you replace the | Notice | |
lamp at this stage. The lamp is a consumable item. | ||
| ||
The lamp brightness diminishes with use. This is | Replace Lamp Now | |
normal lamp behavior. You can replace the lamp | ||
| ||
whenever you notice that the brightness level has | Lamp > XXXX Hours | |
significantly diminished. | Lamp usage time exceeded | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
| |
The lamp MUST be replaced before the projector | Notice | |
will operate normally. |
| |
| Out of Lamp Usage Time | |
| Replace lamp (Refer to user manual) | |
| Then reset lamp timer | |
| Order a new lamp at lamp.benq.com | |
| OK | |
|
|
“XXXX” shown in the above messages are numbers that vary depending on different models.
54 Maintenance
