Selecting an input source
The projector can be connected to multiple equipment at the same time. When the projector is first turned on, it will attempt to reconnect with the input source which was in use when the projector was last shut down.
To select the video source:
•Using the remote control or projector
Press one of the Source keys on the remote control, or press SOURCE on the projector repeatedly until your desired signal is selected.
•Using the OSD menu
1.Press MENU and then press 
/ 
until the System Setup menu is highlighted.
2.Press 
to highlight Input Source and press ENTER. The source selection bar displays.
3.Press 
/
repeatedly until your desired signal is selected and press
ENTER.
Once detected, the selected source information will display on the screen for seconds. If there are multiple pieces of equipment connected to the projector, you can go back to the source selection bar again to search for other signals.
•If you want the projector to automatically search for the signals, select On in the System Setup > Auto Source Search menu.
•If you want to use the PIP function, see "Displaying more than one image source simultaneously" on page 35 for details.
System Setup
Language | English | |
Splash Screen | BenQ | |
Projector Position | Front Table | |
Auto Off | Disable | |
Sleep Timer | Disable | |
Menu Settings |
| |
Input Source | ENTER | |
Auto Source Search | On | |
Back | ||
HDMI 1 | NOTE: When | |
| automatically | |
HDMI 2 | searching for a | |
Video | valid input source, | |
the projector | ||
| ||
cycles through | ||
Component 1 | the available | |
signals following | ||
| ||
Component 2 | the sequence | |
| from top to | |
PC | bottom as the | |
| source selection | |
| bar shows. |
Fine-tuning the image size and clarity
1.Adjust the projected picture to the size that you need using the zoom ring.
2.Sharpen the picture by rotating the focus ring.
Connecting with video equipment | 21 |
